iPROTEC Dual Mode Pressure Switch Light Accessories

Your shopping cart is currently empty.

FREE SHIPPING ON ALL RETAIL ORDERS! (EXCLUDES AK & HI)

< Previous
Next >

Dual Mode Pressure Switch

Dual Mode Pressure Switch
Item #:
 5954
This product has been discontinued and is no longer available to be purchased. For more information or warranty support, please contact us here.

Specifications

Length – Coiled – 17.71” (450 mm)
               Extended – 39.37” (1,000 mm)
Weight – 0.15 lbs.
      

Description

You asked; we delivered. You wanted a pressure switch that you could use with your existing NEBO® / iPROTEC™ products. Here it is. The Dual Mode Pressure Switch by iPROTEC™ is just over 17” in its recoiled position, but can extend to over 3’ to suit your specific needs. The most important feature is the dual mode.  The dual mode feature is two buttons in one switch so that you can independently control your lights functions by choosing momentary or steady on. The steady switch uses hard/soft touch technology allowing settings to be changed in two different ways.
       Hard touch: Simply click through the functions (light 
       will turn off in between settings.)
       NOTE: Some lights will reset to first setting (100% ON) 
       after being off for 10 seconds.   
       Soft touch: Press button halfway with no click.  This
       allows the user to cycle through the settings quickly
       without the light turning off between settings.
The momentary switch activates the light only while pressure is being applied to the button.  (Light will change settings with each use. *NOTE: Some lights will reset to first setting (100% ON) after being off for 10 seconds.)  PROTEC™ Dual Mode Pressure Switch is the accessory to have, especially if you already have NEBO® or iPROTEC™ flashlight.   
                       

Features

  • Dual switch incorporates two buttons inside the switch, one for momentary operation and the other for steady on.
  • Specifically designed to be used with the following products:
    • #5557, #5581, #5599 & #5610 NEBO® REDLINE®
    • #5565 PROTEC™ Laser / Flashlight Combo
    • #5566 PROTEC™ Elite Laser / Flashlight Combo
    • #5586 U.S. Army TAC-110Z
    • #5463, #5564 NEBO® CHAMELEON™
    • #5624 NEBO® REDLINE® 220 Lumen Bright Light
    • #5630 PROTEC™ REDLINE®
    • #5631 PROTEC™ GREENLIGHT™
    • #5632 PROTEC™ REDLIGHT™
    • #5929 PROTEC™ PRO-220 Light
Q - What is the Prop 65 warning, and should I be worried before I purchase?
A - Our “WARNING” notices are mandated by California Proposition 65. We believe that our products are completely safe for consumer use and if any Prop 65 listed chemicals were to be present, we believe they would be within the safe harbor levels for exposure as published by Prop 65.
Our lighting products use Polycarbonate (PC) lenses for light projection, and Bisphenol A (BPA) is a precursor chemical used to make PC lenses. Prop 65 identifies BPA as a cause of reproductive toxicity.
Our lighting products use Acrylonitrile Butadiene Styrene (ABS) plastic for battery carriers and other enclosures, and Styrene is a precursor chemical used to make ABS plastic. Prop 65 identifies Styrene as a chemical that can cause cancer.
Please note that PC and ABS plastics are not listed polymers under Prop 65, but the identified precursor chemicals are listed and in some cases these finished plastics may contain low levels of the chemical in the plastic. Therefore, out of an abundance of caution we decide to adopt this marking in 2017 to alleviate any legal issues that could arise from an improperly marked product sold in California. These warnings are not required by FDA or other Federal agencies.
California Prop 65 WARNING
Shopping
Brands
Customer Service
About
My Account
Social

Need some assistance?

Call: 1-800-255-6061

Site By: Idealgrowth

Copyright @ 2019 Alliance Sports Group, L.P. All rights reserved.

Site By: Idealgrowth