iPROTEC RM190LSG CR123A 190 Lumens

Your shopping cart is currently empty.



Item #:
This product has been discontinued and is no longer available to be purchased. For more information or warranty support, please contact us here.

The RM190LSG is a rail-mounted firearm combo that features 190 lumens of intense white light and a green laser sight. Light of this magnitude is enough to dominate an aggressor’s night-adapted vision; ideal for military, law enforcement and self-defense.

• High-power 190 lumen LED

• Green, adjustable (<5mW / 532nm)

• Light: 190 Lumens - 1 Hour / 92 Meters
• Strobe: 190 Lumens – 2.25 Hours / 92 Meters
• Green Laser Sight: 457 Meters

• Adjustable hinge mount design; no tools required
• For rail-equipped pistols and long guns;
  does not fit subcompacts

• Anodized aircraft-grade aluminum;
  water and impact-resistant

• Light: Side-positioned ON/OFF toggle switch
• Laser: Bottom-positioned ON/OFF switch

• Laser adjustment hex wrench included

• 1 CR123A battery included for light
• 1 CR2 battery included for laser

• Size – (L) 2.875” x (W) 1.25” x (H) 2. 5”
• Weight – 0.2375 lbs.

• D 700,674

Q: Can I use a Rechargeable battery in this gun light?
A: No, the RM190LSG Flashlight only version uses a CR-123a packaged with the product.
This is a nominal 3.0 volt battery. Using a rechargeable version, also known as a 16340 secondary lithium battery, will appear to work without a problem, but in fact has the following issue: The RM190 is designed to work with a primary (non-rechargeable) CR-123a and as such does not have an over-discharge protection built in.  It will drain all of the battery power without monitoring its charge status.  As a result, the rechargeable battery will be drained well beyond the safe discharge level of 2.5 volts.  The longer it its in a fully discharged state, the worse its effective capacity becomes until it is non-functional as a battery.  Attempts to re-charge will fail. If the User removes the battery before it discharges below 2.5 V and recharges it every time, there will not likely be any other adverse functions. As always, we do not recommend the Consumer modify and operate our products in ways other than the recommended configuration.
Q - What is the Prop 65 warning, and should I be worried before I purchase?
A - Our “WARNING” notices are mandated by California Proposition 65. We believe that our products are completely safe for consumer use and if any Prop 65 listed chemicals were to be present, we believe they would be within the safe harbor levels for exposure as published by Prop 65.
Our lighting products use Polycarbonate (PC) lenses for light projection, and Bisphenol A (BPA) is a precursor chemical used to make PC lenses. Prop 65 identifies BPA as a cause of reproductive toxicity.
Our lighting products use Acrylonitrile Butadiene Styrene (ABS) plastic for battery carriers and other enclosures, and Styrene is a precursor chemical used to make ABS plastic. Prop 65 identifies Styrene as a chemical that can cause cancer.
Please note that PC and ABS plastics are not listed polymers under Prop 65, but the identified precursor chemicals are listed and in some cases these finished plastics may contain low levels of the chemical in the plastic. Therefore, out of an abundance of caution we decide to adopt this marking in 2017 to alleviate any legal issues that could arise from an improperly marked product sold in California. These warnings are not required by FDA or other Federal agencies.